Sentence examples for using the simpler model from inspiring English sources

The magnitude of the maximum specific growth rates obtained from calibration of the column-experiment results using the simpler model exhibits dependency on pore-water velocity and initial substrate concentration (C0) for most cases.

The average value of the parameter b was 3.47, corresponding to a time constant of ∼300 ms for the predictive acceleration term and the average value for a was 7.12, corresponding to a main time constant of 140 ms. This latter value is comparable to the value of 160 ms found using the simpler model.

By using the simpler model described in the Technical Appendix part B, we performed a sensitivity analysis (Appendix Figure) on the effect of city size and travel rates on epidemic spread.

The proposed branching process offered a good fit to the data, and we investigated whether a similar fit could be obtained using the simpler model that does not allow cells from returning to a resting state once activated; that is, we set = 0 in the full model.

Even when using the simpler models commonly utilized in the literature, it is computationally expensive to predict the steady-state response of these structures to static and harmonic loads.

The mean values calculated for the various measurements (details below) were all analysed using the simple model: {text{Metric }} = { exp }left( {{text{Treatment }} + {text{ Region}}} right), + {text{ error}}.

At higher values (λ f larger than 6000 W m−1 °C−1), the numerical solution matches the results obtained using the simple model of [12, 13], under the same operating conditions and with the same time step (0.1 s).

When type I error can be reasonably controlled under these conditions, applied researchers might prefer using the simple model (i.e., LR) for its ease of implementation and interpretation.

The data in Figure 8 were generated using the simple model of coevolution described previously [15].

We have previously described the TM using the simplest model of anisotropy, the transversely isotropic model, in which there is a single family of parallel fibers embedded in a matrix whose elastic properties are the same in any direction perpendicular to the fibers [16] (Fig. 1).

Hence, the impact of treatment is under-estimated using the simple model.