Sentence examples for using the respective values from inspiring English sources

The corresponding probability for controls was calculated using the respective values for b and d.

In the model, the steady state level of the SC pool S* varied by more than a factor of two between the vegetative and the transition meristem using the respective values for the cell proliferation rate (see Figure 4A).

A minimum to maximum range was also identified by using the respective values within a specific age group.

Using the respective values for volume at 5 min as passive reference values, AVD was computed to be 30.8 ± 0.7, 22.2 ± 0.7, 12.1 ± 0.5 and 7.2 ± 0.7% for 330, 400, 500 and 600 mosmol/kg-H2O, respectively (calculated as the volume at 5 min minus the volume at 120 min).

The coefficient α22 for longitudinal waves and α21, α23 for transverse waves can be obtained from formula (11) using the respective value of (left (frac {Delta t}{t_{0}}right)) from the measurements of S20C to S50C specimens.

With respect to worst-case assessments, relationships can be evaluated for 90 and 95%% quantiles of leaf deposition values in an analogous way by using the respective quantile values in the above equations instead of the mean leaf value, (bar{D}_{text{i}}).

The 2dPCH histograms of CpG-TLR9 and non CpG-TLR9 complexes could be fitted well with a single component (i = 1, χ2 = 1.43) using the respective brightness values of the diffusing particles recorded in the green and red channels.

All 3-way and 2-way interactions between variables were assessed against a 10% significance level by using the respective P values from adjusted (Wald) hypothesis tests in the table of regression coefficients.

Single-point ligand binding experiments were conducted at a [3H]NT concentration of 2 nM, and the amount of specifically bound [3H]NT was then corrected for fractional occupancy using the respective Kd value [12].

To determine the accuracy of the intensity measurements and sensitized emission calculation, we plotted the proximity ratios measured in all three strains in metaphase and anaphase as a function of corresponding GFP, mCherry, and sensitized emission intensity (Fig.  2a, GFP and mCherry signals are normalized using the respective cumulative average values).

BEs reported in previous studies demonstrated a high variability depending on the nature of substrate, type of supplementation, and the strain(s) used; still, the respective values reported are in most cases lower than those achieved through the use of TPOMW containing media.