Sentence examples for using the peak height from inspiring English sources
The classification of carbonaceous chondrites by IR spectroscopy has been reported by Osawa et al. (2005) using the peak height ratios of hydrous components.
The absorption capacity (AC) is calculated as follows: AC = W 1 – W 2, where W1 is the total mass of mercury that flows through the system during the experiment time, calculated by multiplying the time of the experiment, mercury concentration in the gas, and the gas flow rate; W2 is the mass of mercury not retained in EHg (W2) calculated using the peak height.
The CrI was estimated using the peak height method [ 45] (Table 1).
The peak score can be calculated using the peak height or read count.
We consequently partitioned the peak populations into low-confidence and high-confidence groups using the peak height threshold of 10.
In the second method, the van't Hoff denaturation enthalpy and entropy values were calculated using the peak height maxima obtained from the derivative melting curves, (dθ/ dT max [ 28].
Peak heights for each probe were intrasample normalized using the peak heights of reference probes in the same sample.
For the data analysis we calculated the relative probe signals using the peak heights of PCR products.
Peak heights of observed mass features were extracted from the NETCDF files and aligned according to retention index and processed into a standardized numerical data matrix using the TagFinder software [ 67]. Background subtraction of peak heights was performed, if required, using the average peak height of non-sample controls.
A statistical two-sample t test conducted on the samples showed that the I D /I G ratios for the layers obtained with and without oscillation, calculated using the direct peak height method, were statistically different (p value = 0.031 at 95% confidence); thus oscillation has some distinct effect on the process and the layers obtained.
Even at blast counts less than 5 percent, clonal cells are detected using the SNP peak height skewing data, implying that the majority of bone marrow cells may be clonal even when samples have low bone marrow myeloblast counts (Figure 2).
