Data were coded and thereafter analyzed using the frequency procedure of SAS SASS 2005) for socio-economic characteristics of respondents and related variables.
(SAS Institute Inc., SAS Campus Drive, Cary, North Carolina 27513, USA) Using the frequency procedure in SAS, the distribution of risk factors of interest among cohort members (Table 1) was evaluated.
The common vibrometric technique (d33 meters) is not suitable for the measurement of temperature dependences, and therefore we used the frequency method to perform the desired procedures.
The approximate frequency obtained using the second procedure is more accurate than the frequency obtained with the first one and the discrepancy between the approximate frequency and the exact one is lower than 1.28%.
The approximate frequency obtained using the second procedure is more accurate than the frequency obtained with the first due to the fact that, in the second procedure, application of the harmonic balance method produces an infinite set of harmonics, while in the first procedure only two harmonics are produced.
Having a preamble of the form shown in Figure 3 at the beginning of each superframe, we are able to estimate the frequency offset using the same procedure as in timing offset estimation.
To circumvent this problem, we propose to replace the current allele frequencies with estimates of base allele frequencies using the estimation procedure developed by Gengler et al. [ 21].
A numerical simulation of a single-axis random vibration test of a cantilever beam is conducted using the traditional frequency-domain procedure (FDP) and the proposed time-domain procedure (TDP).
The calculation of Zwicker's loudness, which is needed for a wide range of frequency responses with a fine frequency resolution, using the finite element procedure usually requires significant computation time, since a numerical solution must be obtained for each considered frequency.
The appropriate values for transformation of the average pitch frequency, the signal duration (and thus the speaking rate), the glottal source parameters (OQ, RQ, SQ), and the formant frequencies are obtained using the above procedure.
First of all, by using the quartiles of frequencies procedure by SPSS IBMM, Armonk, NY, USA), we simply applied to the classification of patients into four groups according to the average total accumulated irradiation output (TAIO; average W min−1 min−1reatmin−1.
