Sentence examples for using the dose response from inspiring English sources

Figure 2 shows the correlation of rate constants reported in the sources as indicated in "Experimental data", with the corresponding rate constants calculated using the available data on T, RH and pH, using the dose response function, Eq. (7).

Lethal concentration 50 (LC50) of NaF was calculated using the dose response curve analysis.

The results are presented as percentage inhibition to untreated cells, and the IC50 was calculated using the dose response curve (n = 4).

The curves were constructed using the dose response curves package in R. The logistic model with the lowest mean square error was used to determine IC50 values for gemcitabine and AraC as described in Li et al. [ 18].

Normalized values were plotted as an average ± SD of three wells per concentration and these data were analyzed using the dose response nonlinear curve fitting function with Prism 5.0 (GraphPad Software, La Jolla, CA, USA) to determine the half maximal effective concentration (EC50).

The results are presented as percentage inhibition to the negative control (0.5% DMSO) as the following: Percentage inhibition = (1 - O D samples - O D blank / O D Vehicle - O D blank ) × 100 The median inhibitory concentrations (IC50s) were calculated using the dose response curves (n = 3).

This study reviewed three prediction models, and when using the dose-response curve model, the coefficient of determination (R2) was the largest, so this is the model that should be used.

This is a much lower rate of decline than those (98 99% per year) calculated from diclofenac levels in carcasses in Step 8 using the dose-response model that included the datum from the outlier Gb11.

The concentration of the drug achieving 50% growth inhibition (GI50), total growth inhibition (TGI), and 50% cytotoxicity (LC50) was determined by using the dose-response curves with five concentration points of Fe-SP ranging from 10 nM to 100 µM (Fig. 1C).

Using the dose-response functions fitted in this study, QMRA can begin to be applied.

IR generated two lines at the same time using the dose-response datasets of the two cell lines together.