By using the design method described in Section 3.1.3, we have designed a nearly orthogonal polyphase code set with length L=128 and P=4 phases for N=3 radars: specifically, we have obtained the 3×128 code set matrix S=[s n [ i] ] for n=1,2,3 and i=1,2,⋯,128 with (s_{n}[!i] in left {1,exp left (jfrac {pi }{2}right),exp left (jpi right),exp left (jfrac {3pi }{2}right)right }).
The influence of X 1, X 2, X 3, and X 4 on the hydrolysis by the neutral protease was determined using the factorial design described in the previous section.
Using the experimental design described here, all cells in the culture contained the transgene and expressed it at the same level.
The design described uses this actuation system to perform hand rehabilitation therapies, recommended by a physiotherapist.
The Leigh group has extended their initial system using the same design described above, but with two different stations 75 (a fumaramide station and succinamide station).
The feedback performance of these two approaches is compared using the experimental design described in Section "Experimental Setup".
Using the experimental design described above a clear cut influence of drought stress on biomass yield and physiological parameters was observed (Table 1).
Both validation and PCR measures were combined into groups of similar measures (accuracy, efficiency and practicability) and then aggregated to an indicator of method validity, based on an implementation of the fuzzy-logic-based principle for method validation (software program AMPE [ 27]) and using the design and settings described in Bellocchi et al. [ 28].
Data analysis was performed using Design-Expert® using the general factorial design described above using the percentage of correct subject responses to "Did the preceding stimulus train contain a stimulus on the middle fingertip, D3?" for analysis.
