Sentence examples for using the contact probe from inspiring English sources
Scanning was performed by using the contact probe CSC-37 with a cantilever lateral resolution of 3 nm [15].
However, during the initial stages of specimen discharge using the contact probe, a potential arrest was observed for fully charged and partially discharged samples and it was attributed to the time needed for the thickness of a PbSO4 film formed during discharge and the corresponding resistance under the probe's tip to reach a critical value for the discharge to spread to the rest of the sample.
Advancing and receding contact angles of the probe liquids on the gel surfaces were measured using the contact angle meter GBX (France) equipped with a temperature and humidity controlled measuring chamber and digital camera.
The contact probe was placed against the sample, and spectral data were collected.
The source-detector separation for both the collimated probe and the contact probe was 2.8 mm.
AFM micro-scratch tests using sliding contact probe revealed that the friction at surface finish strongly depends on the multiplicity of rough asperities favoring hence the thermal conduction on wear track.
The level of the adjacent cartilage relative to the screw (i.e. the radius of curvature) was measured anteriorly, posteriorly, medially, and laterally using a contact probe that was provided with the implantation set.
This measurement, used in our case, is prone to error due to possible misalignment of the contact probes.
Generally, the electric VdP measurement is used with lithographically etched pattern, but if there is a good ohmic contact, it is possible to measure without it by placing the contact probes on to the sample.
Use the contacts you already have.
