This article originally appeareDrugsVICE US.
The hydrolysis of sodium toluene sulfonate (STS) in sub-/supercritical water in the presence of CO2 was investigated using a continuous flow system at the constant pressure of 250 bar.
Plots were mechanically inoculated at the unifoliolate growth stage using a high-pressure sprayer at the constant pressure 250 psi.
Large discrepancies among the laminar flame speeds and Markstein lengths of methane/air mixtures measured by different researchers using the same constant-pressure spherical flame method are observed.
The effect of nonspherical (i.e. cylindrical) bomb geometry on the evolution of outwardly propagating flames and the determination of laminar flame speeds using the conventional constant-pressure technique is investigated experimentally and theoretically.
CRD was performed by inflating the balloon using a constant pressure barostat (Model IIR, G&J Electronics, Toronto, Canada) synchronized to the fMRI magnet.
Push the plug follower through the cylinder, using constant pressure to remove the plug.
Each core plug was placed in the core holder and then flooded continuously with brine using a constant pressure pump until the core was fully saturated with the brine.
The right lung was flushed through the pulmonary artery with saline, and fixed with a 2% formalin-based solution through the pulmonary circulation, using a constant pressure of 22 cm H2O.
These patients were ventilated with PCV using a constant pressure amplitude and the change in impedance represents the change in volume; thus, for each pixel the compliance could be calculated.
