To address this, we carried out a sensitivity analysis, calculating mean time from diagnosis to AMI in two ways, using the observed date for these subjects and also using the maximum possible interval of 10 years.
In this paper we used the fast k-tuple distance measure of Wilbur and Lipman [ 25], as implemented in ClustalW [ 5], using the maximum possible k-tuple size of 2 (for protein), to make the distance calculation as fast as possible.
To highlight the speed-up obtained by resorting to hardware acceleration, the algorithm implemented by the proposed hardware modules has also been described in C and compiled (using the maximum possible optimization level) for the LEON3 processor.
For simulations in which the number of MPI processes calling FFTW3 is equal to or larger than the number of available chunks, we could select an arbitrarily smaller number of processes to perform the FFTW3 call, since it seems that using the maximum possible number of chunks and MPI processes does not lead to the fastest performance of the DFT.
We performed further ROC analyses this time using the maximum possible over and estimates of wear from the wear calculations combined with the maximum and minimum reproducibility error from metal ion analysis.
We found that even by using the maximum possible gradient (1,200 G/cm), it was hard to get any significant signal attenuations to estimate the diffusion coefficients for the Rf group and the PEG chains.
The demand-flow system reduced inspiratory imposed WOB by 30% to 56%, inspiratory imposed PTP by 38%to59%9% and expiratory imposed WOB by 12%to49%9% compared to using a maximum possible continuous fresh gas flow of 60 l minute-1 (Table 1; Figure 4).
The mutant-to-wild type ratios were calculated using the maximum possible values, which included reads that also matched the closely related paralogues when an individual miRNA gene was studied.
We used the maximum possible different grid positions for every image in order to ensure the accuracy of the calculation, while we calculated the box counting dimension for both cross-sectional and top view SEM images of different magnifications.
The main idea of these power control schemes is to use a maximum possible power level for transmitting RTS/CTS and the lowest acceptable power for sending DATA/ACK.
