Sentence examples for using concentrations of the from inspiring English sources
Flowers and Kenneth Farley, a geologist at the California Institute of Technology in Pasadena, are employing yet another approach: using concentrations of the noble gas helium in calcium phosphate minerals called apatites found in the canyon's rocks.
This rate is significantly greater than the steady-state erosion rates that we determine for the valley ridge crests and sidewalls (0.08 ± 0.03 mm/yr and 0.20 ± 0.05 mm/yr, respectively) using concentrations of the in situ produced cosmogenic radionuclide, 10Be.
We also found that IgE binding causes no change in receptor mobility, even when using concentrations of the cytokinergic IgE SPE-7 that lead to calcium mobilization and mast cell degranulation.
Moreover, they were performed in a single prostate cancer cell line using concentrations of the drug which were higher than the physiological concentrations of 2 5 μM measured in sera of patients after administration of 400 mg twice daily (Dahut et al. 2008).
Using concentrations of the compounds close to the IC10 (NA, DCPIB and CFTRinh172) or lower (DIDS, 100 μ), we found that DIDS specifically inhibited wound closure of the ANO1-overexpressing clones, similar to NA, whereas DCPIB and CFTRinh172 had no significant effects.
In the Umu-C assay (ISO 13829), a genotoxic effect is significant if the induction factor is above 1.5 compared to the negative control. Figure 2 shows the used concentrations of the different samples reaching an induction factor of 1.5.
For this purpose we again used concentrations of the compounds that gave grossly similar body axis defects (5 µM BT10, 0.1 µM ATRA).
Then commonly used concentrations of the active ingredients for each type of application were derived.
In addition, many of these studies use concentrations of the specific ligands that exceed circulating physiologic levels.
This resulted in a total of 50 scenarios (see Table S1; additional file 2) and about 220 formulations (i.e. combinations of commonly used concentrations of the active ingredients with the 50 scenarios).
The measurements were therefore corrected using concentrations of volatiles and coefficients according to the method by Huida et al.[ 37].
