Sentence examples for using a sufficiently high from inspiring English sources

It is shown that using a sufficiently high deposition temperature of >500 °C, high deposition rates and nitrogen pressure of ≥0.002 mbar, hardness of ≥50 GPa is achieved in the binary nc-TiN/a-Si3N4 system, provided the oxygen impurities are below about 0.2 at.%.

However, despite the advantages of the proposed approaches, their wide use is limited by the high cost of ionic liquid [12], high content of unwanted oxygen-containing defects in N-graphene [12 14], environmentally adverse concentrated solution of ammonia, using a sufficiently high potential, and a prolonged ultrasonic treatment [14].

A far reaching homogeneous distribution of the QDs across the aerogels under preservation of an acceptably high PL can be hence achieved by using a sufficiently high cellulose concentration (≥3 wt%) in HMImCl, an appropriate amount of QDs to compensate for the decreasing transparence of the materials or by preparation of samples (films, disks etc).

This study suggests that when a wind tunnel experiment investigates flow oblique to a very slender cylinder, such as attempting to model a stay cable, experimentalists should use a sufficiently high spanwise aspect ratio of the cylinder.

Therefore, our system used a sufficiently high number of protection levels.

In particular, from Figure 10b it emerges that if one wants to guarantee a minimum value of RE (say 0.95), it is necessary to use a sufficiently high value of c.

Because the flow of volcanic plume is considered to be fully turbulent, to correctly reproduce the entrainment efficiency in the plume, our simulations must use a sufficiently high spatial resolution (Suzuki et al., 2005).

For the MC moves to perform this function they must use a sufficiently high temperature to overcome small barriers but a low enough temperature to avoid mitigating the effectiveness of the minimization moves.

Therefore, we used a sufficiently high amount (10 ng) of total RNA in the initial reverse transcription and first 10 cycles of PCR.

But by using a sufficiently-high number of tests, this problem could be resolved.

The possibility that this was due to additional activation of PLA2 by IL-1β treatment, as observed in fibroblasts [34] and after cerebral ischemia [35], was tested by using PACOCF3 at a sufficiently high concentration as to block all PLA2 isoforms [21].