Sentence examples for using a source measurement from inspiring English sources

The current density-voltage (J-V) curves of solar cells were obtained using a source measurement unit (Keithly 2400).

The DC measurements and AC complex impedance spectroscopy of the GO-film-functionalized IDE were performed by using a source measurement unit (Keithley 2400, Keithley Instruments Inc., USA) and an LCR meter (Wayne Kerr, 4100, Wayne Kerr Electronics, UK), respectively.

The electrical properties of CFO thin films were tested in the air using a Keithley 2400 source measurement unit (Keithley 2400, Keithley Instruments Inc., Cleveland, USA).

Current density voltage (J– V) characteristics were acquired using a Keithley 2635 source measurement unit under AM 1.5G 100 mW/cm illumination in a nitrogen-filled glovebox (<0.1 ppm of O2 and H2O).

They found, through simulations performed using a point source-detection measurement geometry, that the reconstructions performed by solving the non-linear problem using a Newton-type method were more accurate than the reconstructions obtained using linearised forward models and linear regularisation methods.

By using a coherent source spectrometer, first measurements of terahertz dynamical conductivity (absorptivity) spectra of Ge/Si 001) heterostructures were performed at frequencies ranged from 0.3 to 1.2 THz in the temperature interval from 300 to 5 K.

The sizes of the nanocrystals were determined by DLS measurements using a HeNe source (λ = 632.8 nm) and a photomultiplier as detector.

ALARM (Advanced Local And Regional Modelling system), a model for spread from a point source using a combination of measurements and a database of simulated wind and turbulence fields was used, where the topography of the terrain is also included [ 14- 17].

The method was proposed and demonstrated using a point source and acquiring simultaneously speckle measurements at multiple distances using 2D array of detectors like a CCD or CMOS camera and/or measuring speckles at different exposure times.

Therefore, Fig. 8 illustrates that the surface-mount sensors produce equivalent or improved consistency of surface wave transmission and velocity measurements compared to the measurements using a manual impact source.

Therefore, it is possible to express water flux variation of the membrane element based on the results from the membrane sheet measurement using a practical water source.