Sentence examples for using a resolution of from inspiring English sources

For both databases, the spectrograms are computed by using a resolution of 512 points.

Analysis of the prepared beads was performed using a resolution of 30× to determine the diameter of 10 randomly selected beads.

A total of 10 simulation runs were carried out with each run simulating for 3,600 s using a resolution of 8 time-steps per second.

The cephalometric analyses were performed digitally by means of the Radiocef Studio 2 program (Radiomemory Ltda, MG, Brazil), using a resolution of 300 dpi for the teleradiographs [9].

FT-IR studies were carried out in dispersive mode on thin film samples using Perkin Elmer FTIR spectrophotometer (model Spectrum RXI,UK), within a range of 400 4,400 cm−1 using a resolution of 4 cm−1.

For this purpose, the radiographs were digitized by a table scanner (Cranex D® Soredex Orion Corporation, Tuusula, Finland) [10], coupled to a transparency reader, using a resolution of 300 dpi, and saved in TIFF format (Tagged Image File Format) without compression.

If you scan documents, you should use a resolution of no less than 600 ppi to yield a minimum of 6,000 pixels along the long axis.

Low magnification fluorescence microscopy uses a resolution of 500 µm to 1 mm and is used to monitor phenotypic effects on entire cell populations.

For MS/MS, we used a resolution of 17,500 at m/z 200, with an isolation window of 2 m/z.

For this study, we used a resolution of 10 μm in the z direction, which resulted in ~500 z-slices per kidney [ 21].

The μCT analysis performed by Mackenzie et al. [20] used a resolution of 5 μm, which although adequate for determining overall changes in cortical bone volume and porosity, was not sufficient to provide detailed information about the osteocyte lacunae.