Sentence examples for using a kinetic spraying from inspiring English sources

Nanocrystalline (nc) Al matrix composites reinforced with multi-walled carbon nanotubes (MWCNTs) (1.0 and 3.0 vol.%) were fabricated by mechanical attrition and consolidated using a kinetic spraying process, followed by heat-treatment at a homologous temperature of 0.67 T/TM for 1 4 h.

As a solution to this problem, we herein demonstrate an additive-free electrode fabrication process, where reduced graphene oxide (rGO) is coated onto a current collector using a supersonic kinetic spray technique (spray-rGO).

A kinetic spraying process that was essentially a solid-state deposition process was used for the formation of a fully amorphous coating.

Using a spray bottle, spray about only 1 squirt of water in the cup.

If using a spray bottle, spray approximately 15 centimeters (5.9 in) away from your underarm.

Multiwalled carbon nanotube (CNT) reinforced aluminum nanocomposite coatings were prepared using cold gas kinetic spraying.

This paper describes the deposition of metallic coatings using the kinetic spray process (also referred to as cold spray or cold gas dynamic spray).

Measurements were done using a concentric sea-spray nebulizer and a cyclonic double pass spray chamber.

You can also use a spray but spray 4 inches (10 cm) away from the wood.

Coating of hard powder materials on hard substrate using kinetic spray technique has also been considered a difficult phenomenon.

PLA particles were obtained as dry powders by spray drying polymers solutions using a laboratory-scale spray-dryer (Büchi Mini Spray Dryer B-290, Switzerland).