Sentence examples for using a high pass from inspiring English sources
A sampling rate of 256 Hz was used and frequencies below 2 Hz were eliminated by using a high pass filter.
All remaining functional images were subjected to a number of preprocessing steps: 1) motion correction, 2) slice timing correction 3) linear trend removal using a high pass filter and 4) transformation of the functional data into Talairach coordinate space [32].
To quantify muscle tone, raw EMG signals were filtered between 0 10 Hz in SleepSign for Animal using a high pass filter, which eliminated body movement artifacts, and were full-wave rectified, integrated, and quantified in arbitrary units, for every 4-s epoch, using the "integral" function of SleepSign for Animal.
The fMRI data were filtered using a high pass filter of 128 s.
Use a "High pass" setting in your audio to the film.
The new discretization procedure is based on separating small and large scales of the flow using a high-pass filter.
The first method (dcc) separates the data into clusters by means of a convolution operation, using a high-pass filter.
Intensity images were obtained using a diverging lens in order to increase the diameter of the laser spot on the sample to 30 μm and by measuring within the spectral range of 875 1000 nm using a high-pass filter in order to cut off the emission from the wetting layer and the substrate.
A 500-W xenon lamp was used as the light source to provide visible light by removing infrared light with a quartz wafer filter and cutting ultraviolet (UV) light using a high-pass filter with a cutoff of 380 or 420 nm. Figure 1 shows typical planar and cross-sectional FESEM images of the samples.
The PolaRxS and the GSV4004 receivers use similar algorithms to provide the amplitude scintillation index S4 (standard deviation of the received signal power normalised by its mean value) and the phase scintillation index, SigmaPhi (standard deviation of the detrended carrier phase using a high-pass filter with 0.1 Hz cutoff computed over 1, 3, 10, 30 and 60 s).
The resulting images were temporally filtered using a high-pass filter with a low frequency cut off of 1/400 Hz to remove slowly varying scanner noise.
