Sentence examples for using a diamond bur from inspiring English sources
Using a diamond bur, two critical-sized defects (each diameter ≥8 mm) were created in both sides of the parietal bone under normal saline irrigation (Fig. 1).
This was done using a diamond bur handpiece.
With his consent, after oral prophylaxis, a minimal reduction of the talon cusp was carried out using a diamond bur in a high-speed water-cooled handpiece.
Two vertical grooves (one for the center and another for the corner positions) extending from the occlusal surface to the bottom of the cavity were made for each tooth by cutting the corners of the teeth using a diamond bur to accommodate K-type thermocouples with a diameter of 0.5 mm (TT-K-36, Omega, Stamford, CT, USA) within the cavity.
The enamel surface was removed using a diamond bur (KG Sorensen 4054, Cotia, SP, Brazil), and then the dentin surface was ground flat with water-cooled carborundum discs (600 and 1200 grades of Al2O3 papers; Buehler, Lake Bluff, IL, USA) and polished with felt paper wet with diamond suspension (1 μm; Buehler, Lake Buff, IL, USA).
The cross-sectioned surfaces of the slabs were prepared using a diamond cylinder bur (GC International Co., Aichi, Japan) for cementing with the prostheses.
After light curing or initial autocuring of resin cements, each bonded sample was trimmed into a mini-dumbbell shaped specimen with the cross-section of 2.0 × 3.0 mm and 1.2 mm rod high), using a diamond cylinder bur and high speed handpiece (KaVo Dental Co., NC, USA) with air-water spray.
After completing the experiments, the probes were cut sagittally by using a diamond band saw with a 0.3-mm diamond saw blade.
The filling material was removed coronally to the extent of 2 mm deep by using a cylindrical diamond bur number 50 (KG Sorensen, Cotia, SP, Brazil).
A diamond bur was used to partially grind the lingual face of the crown and then received the same ground and flattened protocol that was done at the buccal surface.
The occlusal adjustment was carried out with a diamond bur (Komet 368EF.204.023, Gebr. Brasseler GmbH & Co. KG, Lemgo, Germany), and the polishing was performed using a series of silicone polishers (Komet 9400, 9401, and 9402) with a 5000-rpm speed under water irrigation.
