Sentence examples for using a constant temperature from inspiring English sources

The non-uniform distributions of surface temperature indicate that using a constant temperature or heat flux as boundary conditions may cause numerical errors.

Charging of modular thermal energy storage tanks containing water with submerged Phase Change Materials (PCMs) using a constant temperature coil heat exchanger was numerically investigated.

Simultaneous measurements of inlet velocity and heat release rate oscillations were made using a constant temperature anemometer and photomultiplier tubes with narrow-band OH∗/CH∗ interference filters.

Because of the drawbacks resulting from using a constant temperature, calorimetry has been developed with scanning mode and temperature programming with a constant heating rate.

Cavity configuration, flooding condition, and pumping capacity of aerated disc-type turbines were measured as a function of operating conditions using a constant temperature anemometer.

1.5 vol.% CuO/water nanofluid has been chosen as an intermediate fluid and by using a constant temperature storage control strategy, heat recovery from liquid liquid heat exchangers increases between 5%and9%9%.

The dilute acid pretreatment used a constant temperature of 130°C for 7 min, 3.0 g sample, and 30 mL of a 1% sulfuric acid solution.

In addition, to observe the long-term thermal behavior, the difference in the temperatures of the inlet and outlet fluid of the energy textile is monitored using a constant-temperature water bath and a real simulation system for cooling operating.

Five milligrams of the insulin-loaded nanoparticles were dispersed in 5-mL simulated gastric fluid (pH 1.2) and simulated intestinal fluid (pH 7.4), respectively, and shaken at 50 rpm at 37.8°C using a constant-temperature shaker (SHA-B, Guohua Co. Ltd., Jiangsu, China).

For the case of a finite slab, the governing 2-D heat conduction equation is solved in the non dimensional form using a constant surface temperature as a boundary condition.

Analytical results using a constant waste heat temperature or based on thermal efficiency may result in considerable deviation of system design relative to the varying temperature conditions of the actual waste heat recovery and is regarded as inappropriate.