For this experiment, increasing concentrations of avidin (0, 0.01, 0.03, 0.1, 0.3, 1, 3, 10, 30, and 100 nM) were used to test the surface sensitivity.
SEM was used to test the surface morphologies of the N: ZnO films oxidized at 400 °C for different times, as shown in Fig. 6.
(A) FACS was used to test the surface expression of HER2 proteins in a series of human GC cell lines, including N87, 7901, AGS, HGC27, MGC803, BGC823, MKN45, and primary GC cells from two patients with GC. (B) HER2 expression in N87 and 7901 cells was downregulated via transduction of lentivirus-mediated short hairpin RNA-HER2.
ESCA has since been used to test the surfaces of semiconductors, to check air samples for impurities and to determine the extent of oxidation of a given material.
The Wet Pendulum Test is normally used to test different floor surfaces for slip resistance while the rubber slider is conditioned before testing to provide a constant slip resistance.
Atomic force microscopy analysis (AFM) was used to test the change in surface roughness and cell attachment and proliferation were evaluated using MC3T3-E1 osteoblast cells.
FITC NPs with positive and negative zeta potential were used to test the effect of surface charge on skin permeation of the nanoencapsulated dye.
Its output was validated using a steel surface, then was used to test two sand and fibre surfaces (waxed and non-waxed) through rotations of 40 140°, and vertical loads of 157 1138 N.
Morphology instrument was used to test the chemical structure and surface topography.
Two zirconia ceramics (Katana, Kuraray Noritake Dental and Lava, 3 M ESPE) were used to test the plasma treatment (SAP, surface) with argon gas for one minute (1 L/min).
