The normalized transmitter power required to maintain such average cell SINR was computed and used within the simulation framework.
This paper concludes by comparing the results of the simulation model with theoretical results and drilling experimental data gathered in the hydraulic top drive possessing the same architecture, components, and control methods used within the simulation model.
This paper concludes by comparing the results of this model with experimental data gathered on a Hardware-in-the-Loop (HIL) transmission dynamometer possessing the same architecture, components, and driving cycle used within the simulation model.
At the time of this writing, the simulation engine used within the simulation interface is compatible with versions 1, 2, 3 and 4 of Level 2 SBML models.
Several steps were taken to assure that the developed simulation system fits the current research and engineering needs, including the evaluation of a city's traffic problems, definition of performance metrics, development of V2X-enabled traffic management applications, and the extension of the simulators used within the developed simulation architecture.
Details of the simulation procedures used within this simulation study are provided below.
Both uncertainty quantification (UQ) and sensitivity analysis (SA) are used at multiple states within the simulation to elucidate the behavior of minimum departure from nucleate boiling ratio (MDNBR), maximum fuel centerline temperature (MFCT), and gap conductance at peak power (GCPP).
Result ranges from 43 to 50 mD which is within that used in the simulation model and also estimated from BHP.
However, with the linear model the process arrives at steady state within the time used for the simulation as shown in Fig. 5 by the curve at the edges of the plots.
In this work, CG models were used to represent the components within the simulation system.
