Sentence examples for use a single frequency from inspiring English sources

We are therefore confident that it is sufficient to use a single frequency for all measurements.

This figure confirms that sparse reconstruction using a single frequency completely fails in estimating the sources.

The method uses a single frequency carrier replica for the baseband mixing process, enabling all satellites to perform mixing simultaneously and yielding considerable computational savings.

To compensate for signal-to-noise ratio (SNR) losses caused by using a single frequency carrier replica, the integration interval after despreading is divided into subintervals, and the output from each subinterval then compensated for the known frequency error.

In contrast with the standard continuous driving scheme, which uses a single frequency that corresponds to the electronic transition frequency of NV center spin and a constant amplitude to match the Larmor frequency of nuclei, the frequency-modulated microwave driving fields enable the Hartmann-Hahn resonance to be achieved for an ensemble of NV centers.

The MBS service can be provided over the WiMAX air interface [12], since: high data rate and large coverage using a single frequency network; flexible radio resource allocation that enables dynamic radio resource management in MBS areas; low MS power consumption; low channel switching time, in order to support multichannel services such as mobile IPTV.

high data rate and large coverage using a single frequency network; flexible radio resource allocation that enables dynamic radio resource management in MBS areas; low MS power consumption; low channel switching time, in order to support multichannel services such as mobile IPTV.

Ten optimized design candidates were achieved for each of three cases resulting from minimizing an objective function (the vibration transmission between two points on the structure) which is calculated (i) using a single frequency, (ii) the frequency average over a narrow bandwidth, and (iii) the frequency average over a broad frequency range.

Body composition was estimated using a single frequency bioimpedance method (BIA 103; RLJ Systems, Detroit, MI, USA) to measure body fat percentage.

Both used a single frequency BIA8 system and reported underestimation of FM by the in-built manufacturers' equations compared to DXA [ 5] and to a three-component model of body composition [ 6].

Body composition was estimated using a single frequency bio-impedance methodology (BIA 103, RLJ-systems, Detroit, MI, USA) with tetra polar electrode placement and subjects in a supine position.