Sentence examples for upper stress from inspiring English sources

(Upper) Stress regime and horizontal principal direction of the stress from southwest Honshu to Kyushu.

Based on the above, a lower and upper stress level should be specified for a given friction value.

While this meet the lower bound stress situation of the first approach, it does not meet the upper stress level of this second approach.

Changing upper stress reveals the combined importance of the powder sample friction on the cell side walls, and of internal friction strongly influenced by the grains interlocking in the cyclic powder densification process observed.

For practical radiation protective considerations, a second stress in addition to a low radiation stress can change the protective effect (reduced risk) of a low dose of radiation into a detrimental effect (increased risk), by moving the response through the upper stress threshold and out of the protective window.

The lower (non-stressed) and upper (stressed) baselines were measured to calculate crop water stress index.

The lower (non-stressed) and upper (fully stressed) baselines were determined empirically from the canopy and ambient air temperature data obtained using infrared thermometry and vapour pressure deficit (VPD) under fully watered and maximum water stress crop, respectively.

The asymmetry of the radial displacement is due to the fact that the region of the upper bending stress (see Fig. 19) is relieved because of the progressive radial displacement, while the lower region is additionally stressed.

Simplified method to evaluate the upper limit stress intensity factor (SIF) range of an inner-surface circumferential crack in a thin- to thick-walled cylinder under steady state thermal striping was considered in this paper.

Most of the previous studies were conducted in western countries [ 5, 6, 8, 10- 12] and were done before the era of extensive use of pharmacological prophylaxis of upper gastrointestinal stress lesions in critically ill patients [ 4].

The case of a surface layer stiffer than the substrate is considered, and general solutions for the upper surface stresses of the layer, the interface stresses between the layer, the substrate, and along the symmetry axis are presented for a relatively thin elastic layer.