In total, 18 test areas were measured, together with the planar coordinates of the trees (with d1.3 ≥ 2.5 cm) mapped with tachymeter (SOKKIA SET 4C), as well as d1.3 (in two perpendicular directions), height (h, m), and upper diameter at a height of 6 m (d6, cm) (for trees ≥ 8 m tall).
The under side of the architrave is to be as wide as the upper diameter of the column, at the part under the capital; its upper part equal in width to the lower diameter of the column.
The pore is funnel-shaped, with a large upper diameter of 11 Å and a constriction of 5 Å diameter at the 2′ and −2′ level.
We set an upper diameter limit for a CMBs of 8 mm; a previous study suggests that intracerebral haemorrhage volume (at least in CAA) has a bimodal distribution with a cut off of about 5.7 mm diameter [7], [21], [22].
A round open field with 60 cm in base diameter and 90 cm in upper diameter, surrounded by a 50 cm-high wall was used.
An upper diameter limit of 10 mm was employed for non-reamed nails.
Gordon and Budianto (1999) specified Eq. 1 into a model form, for radiata pine, that included an upper stem diameter term as an additional tree-level predictor (hereinafter referred to as the DH+ model) by expressing some of the parameters of Eq. 1 as functions of dbh, upper stem diameter at 6-m height and total height.
The diameter at breast height (d1.3) is measured for all tally trees, but height, upper diameters, age, and growth are measured only for subsample trees.
For the BASE model, parameter β 1 is constrained to dbh, and for models M3_HABH and GB99, parameter β 1 is constrained to dbh and β 2 to the upper stem diameter (diameter at 6 m for the GB99 model).
Most published studies have pointed to an upper stem diameter measured at approximately 50%% of total height, but others have pointed to diameters measured at as low as 38%% of total height and others at as high as 60%% of total height.
Belleville washer (or) disk spring with higher height to thickness ratio i.e. (h/t) is made with a bearing flat at upper Inner Diameter (I.D) and lower Outer Diameter (I.D) with appropriate radius over edge.
