Sentence examples for under a low flow from inspiring English sources
This study investigated the effect of aligned obstacles on the inclined downward facing critical heat flux (CHF) under a low flow condition using a high-speed camera and an optical fiber microprobe measuring the local void fraction.
To disperse MWNTs in a cement matrix, composites were fabricated under a low flow condition of the fresh mixture, and silica fume (SF) was added to explore the influence of SF addition on MWNT distribution.
The distance between unhydrated cements in the composites prepared under a low flow condition was narrowed, as shown in Fig. 5b.
Under a low flow rate of H2, such as 1,000 sccm∙min−1, typical SiNWs were grown on the substrate (Figure 4a).
Therefore, the flow rate is proportionate to the applied voltage regardless of the pressure scale except under a low flow rate.
The image analysis demonstrated that the MWNT distribution was significantly enhanced in the composites fabricated under a low flow condition, and DC conductivity measurement results revealed the dramatic increase in the conductivity of the composites fabricated under the low flow condition, which supported the image analysis results.
Even under a "low-flow" oil spill – 5,000 barrels a day spewing into the ocean – oil would flow to Western Australia and Victoria, the analysis found.
A 10-minute shower under a low-flow fixture uses 5 times more water.
The mix proportions for composites fabricated under a controlled low flow condition (from 114 to 126 mm) with various MWNT contents are presented in Table 2, which will be dealt in Sect.
The albumin secretion activity of pig FLCs was well maintained under an extremely low flow rate condition (4.8 mm/min in the reactor), and activity higher than the 3D stationary cultures was detected at a later stage (after 20 days in the perfusion cultures).
The compositional gradient may not be significant under a low gas flow rate; however, it will likely be significant under a high flow rate because the dissolution rate of the metal components directly depends on the vapor impinging on the liquid catalyst.
