Sentence examples for ultimate rate of from inspiring English sources

It develops a quantitative approach to information as a means to answer two fundamental problems: the ultimate level of data compression (how small can a message be, given the same amount of information to be encoded?) and the ultimate rate of data transmission (how fast can data be transmitted over a channel?).

There is little data on the effects of screening the general population on the ultimate rate of suicide.

Neck dissection was performed in 10 of the 11 patients; seven of these cases were successfully salvaged, and the ultimate rate of neck control was 92%.

Figure  3 shows that worker density, which should be causally related to encounter rate, strongly determines the ultimate rate of rejection in an agent-based model.

The present study clearly demonstrates that bovine cartilage explants can, at least partially, recover from IL-1-induced degradation by synthesizing new GAG but that the ultimate rate of recovery may be dependent on the degree of initial depletion.

Partial admixture, or population structure, could also be an explanation as Tachida (1994) in a finite island model showed that the initial rate of decay of LD is increased by finiteness of the population but that the ultimate rate of decay is decreased.

If we assume that the ultimate repayment rate will continue to improve in proportion to the timeliness of early repayment installments, an ultimate repayment rate of between 85% and 95% would be a reasonable prediction for today's loans.

At the same time, due to plastic deformation is too large, severe pressure depletion will lead to the decrease in porosity and permeability in the later stage of steam stimulation, which is not conducive to the ultimate recovery rate of the oilfield.

However, the relatively limited follow-up precludes evaluation of long-term problems like posterior capsular opacification and retinal detachment and the ultimate success rate of the procedure.

Sanchis et al. (2014) reported low mineralization of MCPA (<25 % after 28 days), which is in accordance with the low ultimate biodegradation rate of MCPA by the isolated microbiota.

It can be concluded that the ultimate biodegradation rate of a chemical will be a balance between the global structural features and some local structural features, the presence of particular functional groups (Sabljic, 1991).