Sentence examples for ultimate decrease in from inspiring English sources

However, once they begin to flourish at a particular location, the feedback aspect of the model will render the regions less advantageous, leading to an ultimate decrease in population.

The fraction of wild-type acinar cells incorporating BrdU was relatively low at this early time point, leaving open the possibility that an additional defect in survival, manifested at an intermediate time point not yet analyzed, could have contributed to the ultimate decrease in ABKO acinar cells at 14 days post-caerulein.

In this prospective study, we evaluated the importance of low doxorubicin dose cardiotoxicity and found that in patients, with the ultimate cardiotoxic decrease in LVEF as proposed by Schwartz et al (1987), the impairment of LVEF was statistically significant as early as after a cumulative doxorubicin dose of 200 mg m−2.

For cubic CZO (x ⩽ 0.2), the ease of reducibility dramatically increased with increasing Zr content, as reflected by an ultimate >40% decrease in reduction enthalpy, with a corresponding shift in onset of reduction to higher pO2.

The results of the DSTCs with circular inner steel tubes indicate that concrete-filling inner tubes results in an increase in the ultimate axial stress but a decrease in the ultimate axial strain of concrete compared to those seen in DSTCs with hollow inner steel tubes.

They reported a decrease in ultimate WAG recovery with decreasing water salinity due to increasing CO2 water solubility.

A decrease in ultimate elongation and an increase in elastic modulus were observed.

The decrease in ultimate strength of columns wrapped by one layer of GFRP and CFRP in retrofit method 2 was 25% and 18.3%, respectively.

This kind of structural damage will accumulate over time, leading to significant decrease in ultimate load carrying capacity of structural members and premature brittle failure.

Biomechanical testing indicated that the MD and HD of dried plum prevented the ORX-induced decrease in ultimate load of the cortical bone as well as the compressive force and stiffness of trabecular bone within the vertebrae.

The slight decrease in ultimate tensile strength in the entire composite may be due to increase in interfacial area as a result of addition of hydrophilic filler to hydrophobic matrix which worsened the interfacial bonding between them thereby decreasing the tensile strength.