Sentence examples for typical equilibrium from inspiring English sources

The typical equilibrium path in the mast packing sequence is characterized by a snap-back phenomenon.

The labeling yield of 125I-Nimotuzumab was 97.6%, and the radiochemical purity was 98.5% after purification Open image in new window Fig. 2 The calculation of K d and B max by Scatchard plot (A), Woolf plot (B) or the software (C). Figure 2A shows an example of a typical equilibrium saturation curve using the radiolabeled assay with increasing concentrations of 125I-Nimotuzumab.

Figure 4.1 Typical equilibrium of water content vs. water activity in foods.

In an exothermic reversible reaction occurring in an adiabatic batch reactor, the maximum conversion (equilibrium conversion) is achieved when the process reaches equilibrium, which is the situation where the rates of forward and backward reactions are equal in a typical equilibrium-limited process like esterification reactions.

To obtain a complete realistic view of the fuel behaviour a typical, near equilibrium, 18-month fuel cycle is investigated.

In this case study, the selection of the process conditions that guarantees operation under a supercritical single-phase state is discussed as a typical phase equilibrium engineering problem.

However, in typical non-equilibrium situations [5 15] these quantum correlations tend to spread [16 26] and thus are not short-ranged after some time - which is the reason why these methods typically break down in such cases eventually.

Therefore, based on PPACO and typical mature limit equilibrium analysis (Spencer method), a new method to analyze the slope stability is proposed.

The model reproduces the anomalous thermodynamics typical of coherent equilibrium including intrinsic hysteresis (for a pressure driven experiment) and a negative bulk modulus.

This steady state coexists with the typical low activity equilibrium and oscillations.

The typical form of equilibrium problems is formulated by the Ky Fan inequality as follows (see [1]): Find  x ∗ ∈ C  such that  f ( x ∗, y ) ≥ 0 for all  y ∈ C, where C is a nonempty closed convex subset of R n and f : C × C → R is a bifunction such that f ( x, x ) = 0 for all x ∈ C, shortly EP ( f, C ).