Sentence examples for typical direction from inspiring English sources
(Typical direction: "At the crossing, there is a bakery. Follow the street right next to it +- 0,2 km").
The weight gained under varying coating parameter were acquired and could be used for designing and given typical direction to multifunctional performance of developed multifacetal coatings in surface engineering application.
Results of M1 indicate that a typical direction cosine value of 0.69 is valid for the turbulent Bunsen flame in this study and the satisfied W estimation under higher turbulent intensities is provided.
It is confirmed that the preferential growth direction of these petals are along crystallographic [113] axis, which has an angle of 65° with the typical direction along b-axis adopted also by the twisted lamellar overgrowths.
(Typical direction: "At the crossing, there is a bakery. Follow the street right next to it +- 0,2 km"). The bicycles we rented had stands attached to the handles, allowing the maps to be mounted like sheet music on a music stand.
The typical direction of the bias is a strong inflation in sensitivity, paired with a concomitant slight deflation of specificity.
Two types of samples denoted as RD (rolling direction) and TD (transverse direction) were compared because the samples along the two typical directions show an obvious anisotropy.
The composite was ground in three typical directions and the experimental investigation of the surface grinding process for this composite is described.
Moreover, the shapes of strain in three typical directions (see Supplementary Figure 2 for the details) during the overcoring process are consistent with the theoretical shape based on the elastic theory14 (see Supplementary Figure 3 for the details).
Four types of samples denoted as longitudinal (L) and transverse (T) to the rolling direction were compared because the samples along the two typical directions show an obvious anisotropy.
With scratching velocities greater than 5 μm/s, the machined depths are consistent in all typical directions except the V 3 direction, in which the machined depth becomes much smaller.
