Sentence examples for two types of plates from inspiring English sources

There are two types of plates, oceanic and continental.

Based on the boundary condition of the other two opposite edges, two types of plates are considered: the RR (both the edges rotationally restrained) and RF (one edge restrained and the other free) plate elements.

A 10-mm medial opening gap was stabilized in each of the five calf tibial models either with four or two-holed rectangular shaped plates with wedges, with four-holed reversed L-shaped plates with wedges, with the combination of these two types of plates, or with six-holed anatomical T-plates.

The suspension was spotted on the two types of plates where E. coli XL-1 Blue MRA (P2) or WL95 (P2) strain was spread.

Numerical calculations are carried out for these two types of plate, with both simply supported and clamped edges, and the backbone curves and mode shapes are determined.

Two types of plate are considered: (i) a plate containing a distribution of flaws such as pores, for which a stress-based fracture criterion is appropriate, and (ii) a plate containing a single dominant crack aligned with the through-thickness direction, for which a critical stress intensity factor criterion is appropriate.

Also presented in this paper is the analysis of the above three types of plates subjected to eccentric square and circular patch loadings.

This study experimentally explores the heat transfer and pressure drop behaviors of helium gas at low temperature in four types of plate-fin channels, namely offset-strip and perforated fins, with different geometrical parameters.

In the study described in this paper, axial coupons were tested for five types of plate steel, including conventional and high performance A709 steel as well as specialty low yield point steels, to investigate the material response under repeated inelastic demands of constant amplitude between 1% and 7% strain.

These plates are rigid segments that move in relation to one another at one of three types of plate boundaries: convergent boundaries, at which two plates come together, divergent boundaries, at which two plates are pulled apart, and transform boundaries, in which two plates slide past one another laterally.

Two types of thin plates are investigated: (1) plates simply supported on all four edges; and (2) plates simply supported on three edges, and with one longitudinal edge free.