Six test pieces are machined to validate the accuracy of the model and the effectiveness of the error compensation system.
Five small plates for [Experiment I] and five test pieces for [Experiment II] had been pre-heated to 100 °C during the optical contact process.
Constancy of the CT scanner was monitored using nine test pieces of maple and spruce.
The audience wasn't quite the proverbial two critics and a dog, but the sight of so many empty seats must have been dispiriting for the players, who dispatched four testing pieces with consummate skill under H. K. Gruber's baton.
[Experiment II] Five sets of test pieces made of optically contacted three Si plates with the same dimension were prepared (Fig. 10) for the shear loading test so that the center piece could be pushed using a pressurizer (Autograph AG-1, SHIMADZU Corp). to generate shear stress on both of the optically contacted interfaces.
Radial compression tests on three different carcass layer test pieces are performed to verify the safety and effectiveness of the proposed equivalence method.
Concretely, area and orientation parameters can classify test pieces in two categories (large and small scatterer sizes) while eccentricity, centroid frequency and BS provide better results since they are able to distinguish among the four different scatterers sizes.
To sum up, from Table 2 and Figures 9(b) and 10, it is important to stress that area and orientation parameters can classify test pieces in two categories (large and small scatterer sizes) whereas eccentricity, centroid frequency and BS provide better results since they are able to distinguish among the four different scatterers sizes.
The residues were recovered from three of five tested sherds, pieces of three painted cylinders from Pueblo Bonito in Chaco Canyon, and dated to A.D. 1000 1125.
Participants in the inter-comparison exercise comprised eight inner-circle partners who primarily used test pieces which were all manufactured at the same workshop, albeit of three different test piece geometries, and ten outer-circle participants who manufactured their own test pieces, of their own in-house geometry.
