Sentence examples for truss model is from inspiring English sources

However, the use of a combined truss model is relatively complicated.

The validation of optimized truss model is done through comparing with experimental test results collected from the literature.

The results obtained indicated that the optimized truss model is indeed more viable representative to the actual internal stress distribution and accurate than existing 45-deg truss model.

In this study, the softened truss model is revised so that the model gives more accurate predictions of the shear strength of short beams.

The proposed optimized truss model is characterized with limiting failure criteria that reflects truly to the actual FRP strengthened beam behaviour.

To simplify the analysis, only the CATM, instead of the combined truss model, is used to calculate the shear stiffness of a RECC column with a high shear span-depth ratio.

The merits of a frame model and a truss model were investigated in predicting the ultimate tensile strength of the tested connections.

The variable angle space truss model was employed to calculate the torsional bearing capacity of RAC and MRAC beams subjected to combined cyclic torsion.

A truss model was proposed but the model can only consider the effect at the bottom sections of cantilever flanged walls loaded at the top which therefore precludes its application in the design of flanged RC structural walls.

Finally, based on the numerically obtained stress fields, an internally statically indeterminate truss model was proposed which clearly visualizes the flow of forces and accurately describes the observed failure load and failure mode.

The strut-and-tie methodology with the use of truss models is known to be suitable for the shear design and analysis of the discontinuity region of the structural members such as corbels, pier caps and deep beams (Bakir and Boduroĝlu 2005).