Sentence examples for trimming angle from inspiring English sources

It outputs reference heading and trimming angle according to position deviations in horizontal and vertical plane respectively.

The simulation and experimental results showed that the quality of trimmed hot stamped surface was poor with not straight profile and small burnish zone, but it can be improved by choosing proper trimming angle and blade radius.

Considering first the dynamic equilibrium of the cushion itself, the craft dynamic trim, including inner and outer drafts and trim angle, is influenced by a number of design and performance parameters of the craft.

The spray rails were designed to control the flow direction and induce a hydrodynamic lift force on the hull bottom to reduce trim angle and increase rise of the hull.

The reason for the decreased track motion resistance and belly drag with the centre of gravity located ahead of the midpoint of the track contact length is a decreased vehicle trim angle.

Moreover, the sinkage, the trim angle and the wave drag predicted by the Neumann Michell (NM) theory, with the local flow potential evaluated using L or La, are in very close agreement.

The launching analysis needs to consider quite a number of parameters including environmental conditions, launch barge specification, ballast, trim angle, local member integrity, etc. Due to the complexity of the operation, there is not a straightforward guideline or procedure for analysis.

In the assumed allowable axial range of centroid under a designed Mach number, a multi-point/objective design optimization mathematical programming model was established against aerodynamic static longitudinal stability characteristics, hypersonic lift-to-drag ratio characteristics under trim angle of attack and off-set location placement of gravity center for the above reentry capsule.

Take it apart and angle-cut and trim the angle of the "V" as shown in the photo above.

However, heeling angles show less impact on speed when compared with trim angles.

Thanks to the continuum nature of morphing approach, the optimal trim angles for the given flow condition could be verified using new full computational fluid dynamic simulations.