Sentence examples for traversing speed from inspiring English sources

The inchworm™ motor traversing speed can be roughly the product of step size and operating frequency.

The measurement was performed by a diamond point (φ = 5 μm) moving along the wire with a traversing speed of 0.135 mm/s at a pressing force of 4 mN.

Although better cutting performance for equal circumferential spacing are predicted by force balance analysis, in situ measurements of instantaneous (net) traversing speed and cutting rate, pick consumption rate and machine vibration show that no significant difference exists between the performances of the two cutting heads.

Although rotating mass of the turret was 750 tonnes (internal barbette diameter 10.2 m), traversing speed was quite good – 7.2 deg/sec.

The design parameters considered in the experiment were rotational speed, traverse speed, and shoulder diameter.

The factors considered are tool rotational speed, traverse speed, groove width and type of ceramic particle.

The FSP parameters analyzed were tool rotational speed, traverse speed, groove width and type of ceramic particle.

In this present work, sheets of Mg alloys were processed under various combinations of rotational speed, traverse speed and tool tilt angle as per the selected experimental design.

In summary, it can be mentioned that by increasing the rotational speed to traverse speed ratio (w/v) the heat generation will be increased.

The effect of other parameters of the treatment, such as the laser energy, beam profile, traverse speed and the mass rate of the feed powder was also investigated.

In order to evaluate the effect of process parameters such as tool rotational speed, traverse speed and axial force on tensile strength of friction stir welded RDE-40 aluminium alloy, Taguchi parametric design and optimization approach was used.