Sentence examples for transverse compared from inspiring English sources

As illustrated in the figure, at the start of phase 1 larger peak displacements were observed in the transverse compared to the sagittal arm configuration.

Four reoperation cases among laparoscopically treated patients included 1 Hartmann and 3 transverse colostomies, compared to 1 case of transverse colostomy requiring reoperation in the OP group.

Although the larger transverse spot size decreases the transverse resolution compared to the retinal imaging mode described in section 3.1, the longer focal depth and long imaging range enables visualization of the posterior lens, vitreous and retina.

The higher correlation of transverse diameter compared with PA diameter with FAC measurements can likely be explained by the relatively easier and hence more consistent measurements of LV end-diastolic transverse diameter compared with LV end-diastolic PA diameter.

Additionally, greater stresses were observed in the linea alba when loaded in the transverse direction compared to longitudinal.

The initial microstresses were almost two times higher in the transverse direction compared to the rolling direction.

In addition, a significantly (p<0.05, post hoc Scheffe method) higher maximum/failure stress was observed under the transverse loading compared to the axial one.

Quad-helix showed more larger amounts of transverse expansion compared with NPE2 in the posterior region whereas the expansion in the anterior area was almost same in both the groups.

The 2024 aluminum plate used to make the disk exhibited mild plastic anisotropy with about 10% lower strength in the transverse direction compared to the rolling and through-thickness directions.

Bars with sand-coating show significantly reduced capacity when loaded in transverse compression compared to the fiber-wrapped surface, and microscopy reveals areas of localized contact with sand particles that support test results.

Very few researchers have come forward and carried out research using woven fabrics in the case of cut resistant fabrics specifically, despite the fact that they possess superior mechanical properties in both in-plane and transverse directions compared to knitted fabrics.