Sentence examples for transmitting mode from inspiring English sources
Consequently, in transmitting mode the power loss in any undesired directions is minimized and in receiving mode the noise level from other angles interfering with the data collection is suppressed, which improves the signal to noise ratio of the imager CMUT array.
This paper reports a new type of transmitting mode electrochromic device that uses the high-contrast electrochromism of poly 3,4-ethylenedioxythiophene) (poly 3,4-ethylenedioxythiopheneelength infrared (8–12 μm).
Actually, when the power constraint is large enough, the "cooperating" transmitting mode will not occur (this is the explanation for the reduction in the gain gap that is observed as the power constraint increases).
In addition, it should fulfill the so-called Markov property [13], and each binary value, i.e., the state value, controls the transmitting mode ("OUTPHASING (O)", "BALANCED (B)").
where λ is the wavelength, k = 2π/λ, η0 is the free space impedance, a1(f ) is the incident wave at the reader's port, Θr = (θreader, ϕreader) is the reader orientation, and is the antenna's transfer function in the transmitting mode of the reader [35].
We report the observation of Coulomb blockade in a quantum dot contacted by two quantum point contacts each with a single fully transmitting mode, a system thought to be well described without invoking Coulomb interactions.
The transmit rate of the CC2420 is 250 kbps, which consumes 62.04 and 57.42 mW in receiving and transmitting modes, respectively.
In beamforming slot, the sources switch to transmit mode with the baseband oscillator running continuously but in reverse sequence.
Push-to-talk (PTT) is a technology that allows half-duplex communication between two users, using a momentary button to switch from voice reception mode to transmit mode.
Prior to that, these body sensors should have switched their radio from idle to transmit mode, which take them a transition time for body sensor radio wakeup (i.e., from idle to active modes [19]).
Since MS-DOS Kermit 3.0 can use RTS/CTS handshaking for half-duplex line turnaround, we were able to control the radio's receive and transmit modes via the interface cable between the radio and the computer.
