Sentence examples for tracking procedures in from inspiring English sources

"It's extending efficiency and effectiveness because we don't use standard tracking procedures in order to do that.

We used this simulated tracking procedure in case subjects became aware of the signal stimulus associations.

We recommend using the tracking procedure in human psychophysical detection experiments to obtain estimates of the threshold and slope and to identify the mode of non-stationarity.

More than 200 UberPop drivers have been fined under fast-track procedures in France, and the company has already been convicted of deceptive commercial practices and fined some $170,000 over UberPop by a Paris court.

Another suggestion he made was to create a fast-track procedure in the crown court, presumably for less serious cases.

Deloitte said that the charges were being brought under a "fast-track" procedure in Italian law, and that use of that procedure was better suited to far simpler cases and "will not provide the partners sufficient opportunity to defend themselves at this stage of the proceedings".

It has been shown that the particle-tracking procedure in the CFD software Fluent V6.0 offers good accuracy at velocities below 12 m/s with Reynolds numbers between 790 and 2150.

An intrahospital casualty throughput system modeled after air traffic control (ATC) tracking procedures was tested in mass casualty exercises.

The tracking procedure consists in determining the new target positions for the successive frames by comparing the covariance matrix C2 (i.e., the candidate position) and minimizing the Riemannian distance (9). Figure 2 depicts two possible searching strategies: the exhaustive search approach (left) and a gradient-based local search or steepest descent approach (right).

This dynamic-probe-protocol was performed in real-time by the operator through eye-detection and controlled a posteriori using the bead tracking procedure described in the methods section, which confirmed that the residual forces applied on the probe in the two-steps-cycle step back of the pipette were kept below 25 pN.

The tracking procedure consisted in determining the center of the bead by adjusting, on each image of the stack, the inverted-intensity of the image along four perpendicular radii of the bead to a Gaussian distribution in order to find the maximum intensity location along both x and y axes (Fig. S6).