Sentence examples for trace as shown from inspiring English sources
The thermal parameters such as glass transition [Tg] and crystallization [Tc] temperatures of the prepared glass were obtained from the DTA trace as shown in Figure 3.
Following Thatcher and England (1998), we considered the problem in a 2-D plane perpendicular to the fault trace, as shown in Fig. 1.
In order to increase the convenience and reality of the simulation, the simulation is separated into two modes: local simulation and recorded trace as shown in Figure 5.
The profile line was constructed perpendicular to the Yammouneh Fault trace line, such that the boreholes were distributed in equal number on both sides of the fault trace, as shown in Fig. 3.
Therefore, in this study we introduce another parameter which is the rate of variation of the SC which is the maximum rate of change of the geomagnetic field during the higher-frequency region of the SC, and without having discontinuities in the trace as shown in Fig. 3.
The RV and left ventricle (LV) areas may be determined via endocardial tracing as shown, though in many cases, an RV/LV ratio of ≥ 1 can be determined visually without routine manual tracing.
We then used our two-step scratching method (as shown in Figure 1c,d) to fabricate 3D nanodot arrays on PC surfaces.Firstly, to fabricate nanodots with a size of 500 nm, we chose two-step scratching traces (as shown in Figure 1c) using scratching angles of 90° and 0° for ripple formation with a period of 500 nm.
The SS electrode exhibited relatively planar surfaces with parallel polishing traces, as shown in Figure 2(a).
This pulse duration is confirmed by comparing experimental (black) and calculated (red) interferometric autocorrelation traces, as shown in Fig. 2(d).
Quantitative estimation of mineral phases shows that all the clay minerals and aluminosilicates disappeared at high temperature (1000 °C), leaving behind SiO2 (78 %–84 %) as the major phase along with other trace minerals as shown in Tables 3, 4, 5 and 6.
From the trace plot as shown in Figure5, it can be seen that each of the three variables used in the present study has its individual effect on SEO (TPH and Cr (VI)) removal by the intrinsic microbial populations in the soil.
