Sentence examples for toughness threshold from inspiring English sources

The sharp toughness threshold in the rubber-modified HDPEs results from a specific micro-morphology of the crystalline component of HDPE surrounding the rubber particles.

This work strongly suggests that an increase in twin density, at a fixed grain size, is beneficial not only for desirable combinations of strength and ductility but also for enhancing damage tolerance characteristics such as fracture toughness, threshold stress intensity factor range for fatigue fracture and subcritical fatigue crack growth life.

The calibration procedure employs a three-parameter Weibull stress model which includes the effects of a minimum (threshold) toughness, Kmin.

The surprise team of the season is going to have its toughness and pain threshold tested in the next two weeks, with consecutive games against the Ravens in Baltimore and the Steelers the next week.

When residual stresses from casting were relieved by annealing, there was an associated decrease in both the fracture toughness and fatigue threshold.

The results show that the fracture toughness and the threshold stress intensity factor of delayed fracture in silicon oil, i.e., stress corrosion cracking, decreases linearly with increasing the applied electric field, either positive or negative.

Mode I and mixed mode I/II fracture toughness, fatigue crack thresholds, and fatigue crack growth rates (FCGR) were measured at room temperature using a four point bending test setup.

I think a lot of it boils down to pain threshold and toughness, and if I had to guess, Deshaun Thomas will be on the court to start the second half.

The results are discussed in terms of ways to estimate fracture toughness and indentation cracking threshold loads more precisely through nanoindentation.

The mode I properties (interlaminar fracture toughness and delamination fatigue threshold) of these epoxy-interleaved CFRP laminates were almost identical to those of the laminates without interleaf (base CFRP laminates).

The derived expression for the fatigue crack growth rate is approximated by:dcdN=0.041EY ΔK1−ΔKth)211−(K1 max/K1c)2where ΔK1 is the stress intensity factor (SIF) range, K1 max is the maximum value of, K1, K1c is the fracture toughness, ΔKth is the threshold SIF, E is Young's modulus, and Y is the yield strength.