Sentence examples for toughness testing from inspiring English sources

Development of an adequate plane strain fracture toughness testing standard.

J-resistance data were derived from the lowest fracture toughness testing data obtained from Ontario Power Generation's PHT (primary heat transport) LBB material testing programs.

The brittle-to-ductile transition (BDT) of stoichiometric NiAl and Ni49Al1Ti alloys was investigated using tensile and fracture toughness testing methods.

On the other hand, the new CTOD calculation formula adopted by the JWES CTOD fracture toughness testing standard uses Y/T, and derived CTOD values from the formula are affected by Y/T.

Fracture toughness testing on the same material/size that exhibited zero compressive plasticity produced both notch and fatigue pre-cracked toughness in excess of 100 MPa m1/2, while a size effect on the magnitude of toughness was similarly demonstrated.

A number of specimen geometries have been developed as suitable candidates for interfacial fracture toughness testing [12 15].

KId data from 140 mm thick single edge bend specimens of two dynamic fracture toughness test series on ductile cast iron from heavy-walled castings were analysed.

In a 0.18DCT fracture toughness test performed at 300 °C of ductile properties, the strength of F82H with helium production was rapidly decreased as compared to that with no helium production beyond a maximum strength in ductile temperature region.

In Pictures: Insane Laptop Toughness Tests.

Table 1 Mode II fracture toughness test geometries.

A fracture toughness test for intermediate toughness materials is developed.