Sentence examples for total slice from inspiring English sources

For Virtex-5, non-pipeline implementation results in 1, 650 total slice with throughput of 764 Mpixels/s, while for Stratix III, it utilizes 1, 571 ALUT with throughput of 922 Mpixels/s.

The maximum throughput using Virtex-5 FPGA is 1654 Mpixels/s with total slice of 3, 419 for 4-stages pipeline, which corresponds to 2.07× more slice and 2.16× higher throughput compared to non-pipeline implementation.

With this method, the epicardial and endocardial borders of each slice as well as the contours of the infarcted area were hand-traced and expressed in percentage of the total slice area.

The areas of the infarction region were calculated by a Pathology Image Analysis System (Topica Inc., Japan) and the ratio of the infarction volume to the total slice was noted.

The low magnification corresponds to approximately 10% of the total slice area and is representative for the complete tissue slice demonstrating that almost all cells die in the presence of higher taxol concentrations in this tumor sample (Fig. 4a).

Interestingly, the increase in phospho-CaMKII was much smaller (and not significant) in total slice homogenates, suggesting that Ng overexpression causes the increase in CaMKII activation preferentially in the synapses.

Sinograms comprise 400 radial and 168 angular bins, 621 total slices (109 direct and 512 oblique planes), and 13 TOF bins (312 ps wide) [6].

Reconstructed data are visually shown at different radial lines in Fig. 3a, b, c corresponding to the middle slice (slice number 18 of 36 no. of total slices) captured at the 100th time point.

In Table 4 it is exposed the amount of FPGA resources consumed by each channel coefficient design, that in some cases reaches the 99% of the total slices and more than 90% of some of the resources (hence, a MIMO emulator design does not fit into one FPGA).

For the CNTLarge sample alone, ten different sites were investigated and only in two cases, evidence of direct cell-CNT interaction was found and this was for a total slice-and-view time of 20 h (excluding the preparatory work).

The total slices with the entire FHNR including cartilage, subchondral bone and trabecular bone were identified on the XY plane images.