Sentence examples for total selectivity of from inspiring English sources

The total selectivity of the catalysts was not influenced by the dopants.

The conversion of 1-decene is 100% and total selectivity of methyl-nonane is 98.4 ± 0.4% at 350 °C.

However, the total selectivity of C2 C4 hydrocarbons is almost not affected by the addition of Mn oxide.

However, the total selectivity of C7 isomers at lower temperatures was very high throughout the deactivation reaction at 210 and 230 °C, taking advantage of the thermodynamic equilibrium.

The total selectivity of the picolines formation is changed slightly––within the range of 41 36 %, while in the composition of isomers noticeable changes occur.

Hence, 270 °C is considered to be the optimum operating temperature because of high CO conversion, high total selectivity of produced light olefins and low CH4.

Hence because of higher total selectivity toward C2 C3 light olefins, a high value of CO conversion, and low CH4 selectivity at the total pressure of 3 bar, this pressure was chosen as the optimum pressure.

However, at a H2/CO ratio of 2/1, the total selectivity toward C2 C3 olefins fraction was higher and the CH4 selectivity was lower; in comparison with the products of the other H2/CO feed ratios under the same operating conditions of temperature and pressure.

The total selectivity toward 1-octene and 1-hexene remained constant at 94 % regardless of the Al/Cr molar ratio over the tested range of TMA contents.

The receptor 3 exhibited total selectivity towards fluoride in acetonitrile.

Therefore, total selectivity and relative impact on a preferred patch type or plant species can be reduced by limiting the numbers of levels available for selection.