Sentence examples for total dispersed from inspiring English sources

Dispersed repeats occur in both H. akashiwo CCMP452 and NIES293 chloroplast genomes, but they are of low similarity and number (less than 100 total dispersed repeats greater than 90% similarity).

At this site, the number of ash layers most closely tracks the total dispersed MAR (that is the sum of HR + IBFA).

The study results quantitatively demonstrated that total dispersed oil concentration and breakup kinetics of oil droplets in the water column were strongly dependent on the presence of chemical dispersants and the influence of breaking waves.

When compared to various ash layer parameters, we find that the MAR of the total dispersed ash component at Site C0011 correlates best with "Thickest Layer" in Unit I.

The accumulation rate of total dispersed ash (gray shaded with filled circles in g/cm2/ky) plotted against parameters associated with the sedimentation of discrete ash layers per 1 Ma (open circles) from Scudder et al. (2014).

Solar PV installations are on the increase and about 1 MW total dispersed installations are going on country wide for low energy applications such as water pumping, street lighting, vaccine refrigerators and community lighting [48].

γw, γ w d, and γ w p represent the total, disperse part, and polar part of surface tension of water, respectively (Ikada et al. [1981]).

In Equation 1, γpw is the surface tension between PS and water, γp, γ p d, and γ p p are the total, disperse part, and polar part of surface tension of PS, respectively.

Previous protected areas were 40,000 acres in total and dispersed over five sites.

The latter can describe either the probability of distance occurring in any direction, based on a histogram of absolute counts, or the probability of a given propagule landing at an infinitely small distance r from the parent (the latter is simply the histogram of counts' density divided by total seeds dispersed, i.e., Q)[4].

All fluorescence was excited with a 532 nm laser (<20 mW total power dispersed over a 1 mm × 0.010 mm area for line imaging) and the emission spectrum from 550 to 900 nm was collected in line scanning (push-broom) mode with a scan speed of 0.04 mm/s and a CCD rate of 4 frames/sec with EMCCD gain set to 128.