Active torque-angle and torque-fascicle length curves will be adjusted for the effect of gravity, and the passive torque measured at the same fascicle lengths will be removed to calculate active torque.
Designing the thread forming fasteners with as-cast holes follows the general rules for designing for the machined holes, including carefully designing the variables such as the assembly torque range, the length of thread engagement, the hole diameter and required failure mode.
These results are typically presented as torques, though the length of the moment arm employed is rarely defined to allow proper evaluation of the torque values presented.
The torque transmitted per unit length of the cylinders turns out to be given by It may be added that if the inner cylinder is absent, the steady flow pattern consists only of the first mode i.e., the fluid rotates like a solid body with uniform angular velocity ω0.
Fascicle length and torque were simultaneously recorded for offline analysis.
wellbore length and torque, to develop a set of Pareto optimal solutions that can aid the selection of less risky/less costly well trajectory designs.
On the cutting performance for Cr Mo steels, non-treated, ion- and radical-nitrided end mills were used, and the cutting length and torque was measured.
It has been shown that torsional behavior of the multi cell tapered beams is affected by layup, geometry, material, length and torque changes.
By minimizing both wellbore length and torque it is likely that a wellbore designed to reach a specific target can be drilled more quickly and cheaply than other potential trajectories.
42 Another possibility could also be that fatigue-induced reductions in the contractile RTD resulted from shifts in the optimal muscle length for torque production, as demonstrated after eccentric damage.
The length and insertion torque values of the parallel area varied as the length of the implant varied among 6, 8, and 10 mm.
