Sentence examples for tools orientation from inspiring English sources

The PQRS has five assessment tools: Orientation – name, date, and place (Adapted from the MMSE).

C3 continuity of the tool tip position and the tool orientation are guaranteed along the entire tool path.

Similar to the tool tip position, the TPAA algorithm is also conducted to estimate the tool orientation contouring error in the unit spherical coordinate system, where equal proportional factors of the tool tip position and the tool orientation arc-lengths are adopted to ensure the synchronization of the tool tip position contouring error and the tool orientation contouring error.

On the basis of upper work, the parameter representation of IUCT is deduced by the parametric expression of coordinate transformation matrix and feed vector, and resolved to three sub models about tool orientation, tool orientation change and cutter runout.

The available range of tool orientation and entry position is clarified in which accurate guidance is guaranteed.

Cutting forces in 5-axis milling cycles continuously vary due to changes in tool orientation and depth of cut.

If the tool orientation is picked inside the ATOR, the resulted surface texture is considered to be acceptable.

Realizing that, a modified particle swarm optimization (PSO) is intergraded into the previous tool orientation translation method.

Some conclusions obtained and the methods utilized can be used to optimize tool orientation and feed rate etc.

Table 2 Sustainability assessment tools shown with their orientations, main strengths and weaknesses and examples of their extensions and combinations with other tools Tool Orientation Strengths Weaknesses Extensions & combinations Cost-benefit analysis (CBA) Economic Monetary valuation of gained benefits.

This review primarily focuses on three aspects in freeform surface machining: tool path generation, tool orientation identification, and tool geometry selection.