Sentence examples for tolerable frequency from inspiring English sources
As can be seen in Figs. 6 and 7, the maximum tolerable frequency offset of the detection algorithm in [2] is about 0.02R b, while the decoding performances of 2 bits MSCDD-PCCD and 3 bits MSCDD-PCCD remain unchanged under different frequency offsets.
The maximum tolerable frequency offset of the detection algorithm in [2] is about 0.02R b, while the decoding performances of 3 bits MSCDD-PCCD remain unchanged under different frequency offsets Fig. 7 BER curves of 2 bits MSCDD-PCCD and 3 bits MSCDD-PCCD under different frequency offsets.
The scores of putative matches are compared to a threshold that is computed based on the tolerable frequency of hits in random sequences (p-value) by an efficient and exact lazy-evaluation method [ 19].
This plot permits the selection of thresholds as a function of total risk reduction and tolerable action frequency.
The 10 mg/m TP300 dose level was tolerable, but the frequency of grade 4 neutropenia during cycle 1 led to the recommended Phase II dose being 8 mg/m for cycle 1, increasing to 10 mg/m in subsequent cycles if tolerated.
It is assumed that the elastic properties of the plate material and the permissible or tolerable error in the frequency of the Kirchhoff theory are known quantities.
One of the equations popularly used to assign a probability of failure on demand (PFD) to a safety instrumented function (SIF) based on tolerable risk and unmitigated event frequency is shown in the equation below.
Design of an appropriate digital filter demands such filter coefficients that will create the desired frequency response with tolerable amount of ripples in the stop band(s) and pass band(s) along with high attenuation in the stop band(s).
This proposed design technique produces low-pass FIR filters featuring sharp cut off, exactly marked pass-band and cut off frequencies along with tolerable pass-band ripple and variable stop-band attenuation.
Notably, the method is not restricted to minima molecular geometries such that optimized structures with negative frequencies are also tolerable.
A bi-directional CR system[5, 6] with multi-antenna relay was presented to improve the spectrum efficiency while keeping the interference towards the PUs in tolerable limits in the case of frequency flat fading channels.
