Sentence examples for tip length from inspiring English sources

Four geometry variables which are; the depth, tip length, pitch and orientation of the cavities are taken into account in order to optimize the aluminum heat sink design.

We have fabricated polymer tips for atomic force microscopy in order to elucidate the effects of tip length and shape on cantilever vibration damping in liquids.

Additionally, the combined effect of AZO and TiO2 thickness ratio along with the fiber parameters such as fiber tip radius, tip length and numerical aperture on the reflectance spectrum has been investigated.

Two-dimensional mesoscopic calculations (i.e. at the dendrite tip length scale) were performed to simulate the evolution of columnar and equiaxed dendritic morphologies including the formation of the columnar-to-equiaxed transition.

The results showed that the trapezoidal groove with groove tip length ratio of δ = 0.5, groove depth ratio β = 0.4, groove pitch ratio of ψ = 3.334, grooves orientation ratio of ζ = 0.00 and Re = 100 is the optimum thermal design for GMCHS with Nusselt number enhancement of 51.59% and friction factor improvement of 2.35%.

The design and performance charts are presented in terms of the performance ratio (PR="Q˙f/Q˙f,max) for the four parameters of the problem: the maximum fin effectiveness (ζmax= λf/αδf), the fin aspect ratio (l/δf), the ratio of the film heat transfer coefficient at the tip to that along the length of the fin, (αe/α) and the fin tip length factor (a).

When the vibration amplitude was rescaled to show the effect of the cantilever width on oscillation damping, the vibration amplitude of cantilevers with various tip lengths was similarly obtained in a long distance range over 50 μm.

Filtering is a good guard against sequencing error and inflated tip lengths in the phylogeny (Figs.  1, 2, 3, 4 and 5).

Although most of the particles have similar tip lengths, few of them were found to contain either no tips or particularly long ones, which is likely related to the fast reaction rate.

In relation to proboscis length, the representatives of the Eurybia species have a significantly shorter tip region than short-tongued species (Mann–Whitney U-test: Z = −2.887, P = 0.002, N = 12), because the absolute tip lengths are similar in all species (Table 3).

Note that shortening tip lengths should be done only after the tree topology has been constructed, because the weights used in the least-squares tree estimation (Eq. 3) apply to the observed values n t * and n s *, not the corrected values.