Sentence examples for threshold contents from inspiring English sources

Poly aniline -nylon 6 comPoly aniline -nylon) prepared by diffusion and chemical oxidative polymerization has very low percolation threshold contents (∼4 wt%) and provides a high conductivity.

However, a higher DLp complex content did not always provide increased gene transfer efficiency to the CHO-K1 cells, because there was a threshold content of approximately 10 μg/cm2.

So a threshold content of fluoride anions (0.2 M) is necessary to form an initial insulating layer and therefore reach the sparking phenomenon.

The maximum anisotropic electrical properties were achieved at the percolation threshold content of the nickel powder, which is the critical point for the formation of an effective conductive network.

Si is shown to continuously slow down bainite kinetics with increasing content, with no threshold content identified and an influence that is stronger than that of Mn or Cr.

Availability of chloride ions is one of the important factors for initiation of corrosion of steel in concrete, because the availability of certain amount of chlorides above the threshold content de-passivates the steel in the concrete.

On the mechanical properties aspect, a threshold value of the NS and NC contents were found so that the compressive, flexural strengths and flexural to compressive strength ratio of the UHPC matrix were found to increase as the NS and NC contents increased towards the threshold content, and then to decrease with the increase of NS and NC contents when the threshold was surpassed.

This theory predicts that a minimum threshold content of polymer is required to provide extended release of drug, and that matrices with a lower polymer content will exhibit more rapid drug release as a result of percolation pathways facilitating the faster penetration of the aqueous medium.

Until the percolation threshold content, the electrical conductivity is determined by the tunneling of the charge through the barrier at the interface, which is caused by the presence of thin polymer layers and depends on the distance between particles and the dielectric constant of the polymer matrix.

Considering the fact that the odor level of each aroma-active component depends on both its content and threshold, the contents of aroma-active components in the 19 CCAs were mean centered and scaled to have a unit sample standard deviation.

The evaluation using LIFE 365, it is shown that arrivals of threshold chloride contents at rebar location are 11.8 years for OPC, 18.2 years for SG30, and 24.3 years for SG50, respectively.