Sentence examples for this cross section was from inspiring English sources

This cross section was found very prone to instability and large-amplitude vibrations were observed also for high values of the Scruton number (product of non-dimensional mass times damping) and relatively low wind speeds.

This cross section was normalized by r 0 which corresponds to the average distance between nearest neighbors.

This cross section was built using the pressure profiles of the wells which are equivalent to the pressure formed at the major feed zones, only.

Modelling the system in 2D implicitly assumes that this cross section is constant along the z-axis.

This cross section is close to half of the maximum emission cross section 3.95 × 10−21cm2 in conventional silica where the FWHM is 35 nm usually.

However, this cross section is important as it allows determining accurate geometric parameters of the studied heterostructure by the known inclination angle.

An image of this cross section is presented in Fig. 7; for Ug = 25 cm/s, a high local gas holdup is concentrated in the center of the bed and extended to the region near the bed wall.

According to Tables 1 and 2, the R/t for the cross-section A-A ratio is higher than the cross-section B-B, so if the springback at this cross section be controlled, it could be reasoned that the springback of the whole piece have been controlled.

In this study, as the cross section was assumed to be a triangle, and measurement resolution was to ± 0.01 mm.

This cross-section was taken to confirm the fact that the dyeing carried out gives well penetrated dyeing and not ring dyeing.

At the top of this cross-section was observed a thin layer with similar size and composition to the previously studied sample.