Sentence examples for thickness product from inspiring English sources

Also, simultaneous enhancement of the transmission magnitude and Faraday rotation of the structure can be obtained by optimizing the optical contrast ratio-magnetic defect layer thickness product.

Minor limitations shown are that the theory is inapplicable near grazing incidence and that it gives only a partial solution at incidence beyond the second critical angle when the frequency thickness product is the variable.

This value is obtained from the measured optical thickness (product of the refractive index and layer thickness, neff × DT).

These measurements, which were recorded as a function of frequency and transducer separation, were concentrated in the frequency bands where the panels were approximately half a compressional wavelength thick (i.e., for frequency-panel thickness products of the order of 1·35×103 Hzm).

Two CryoSat-2 sea ice thickness products derived with independent algorithms are used to initialize a coupled ice-ocean modeling system in which a series of reanalysis studies are performed for the period of March 15 , 2014 September 30 , 2015

The Nb growth exhibited a significantly steeper stress-thickness product slope regardless of the Ti phase state.

This type of approximation is in agreement with the physics of EM induction, which is more sensitive to the conductivity-thickness product than to conductivity variation with depth.

The initial Ti layer grows on Nb with a positive stress-thickness product slope up to ∼2 nm, whereupon it transitions to a slightly negative growth stress slope.

They found that low level of cross flow helped vertical conformance treatment and that a high ratio of permeability-thickness product between high and low permeability zones resulted in increased recovery.

An expression for sheet carrier density has been formulated considering the effect of doping-thickness product and has been extended to calculate drain current, transconductance, capacitance and cut-off frequency of the device.

In-situ monitoring of the curvature not only allows for a determination of the AlAsyP1−y composition, but also to assess the onset of relaxation by means of the strain-thickness product in conjunction with curvature transient simulation.