Sentence examples for thickness of sheets from inspiring English sources

The result is a huge reduction in thickness of sheets without the use of saws.

The average cross-sectional thickness of sheets is measured from the FESEM image, which is close to ~21.0 ± 5.0 nm.

This paper presents comprehensive data and their interpretation on strength, deformation characteristics, ductility and mode of failure of beams in terms of effects of thickness of sheet, concrete strength and amount of tension reinforcement.

The value of the thickness of sheet is 0.34 nm; the elastic modulus is 1.0 TPa; the Poisson's ratio is 0.27; the mass density of the CNTs is 2.3 g/cm3; and the inner and outer diameters of the DWCNTs are 2.2 nm and 3.0 nm, respectively [12].

Some variables, such as tilt angle, size of core cross-section and thickness of sheet shell, have been proved to be effective in controlling the collapse mode and crushing performance of STFD-HAT sections by analysis on energy absorption and RSS of result curves.

We predict the influence of pressure-dependent viscosity on the exiting sheet thickness of the sheet of fluid from the gap.

Three thicknesses of sheet steels were used to fabricate the screwed connections.

With high magnification in Figure5b,c, it is clear that the length of the sheets are about 1 μm and the thickness of the sheets is about 100 nm.

The thickness of these sheets varies between 1 to 2 nm, whereas the size of these sheets is on an average between 500 nm to 1 µm (Figure 4a).

The height profile diagram of the AFM image indicates that the thickness of the sheets is around 23.81 nm, comparable to the typical thickness of single-layer GO sheets (8.09 nm).

The inside walls are sheathed in an amber-colored veneer about the thickness of two sheets of paper, cut from a single log of an African moabi tree.