Sentence examples for thickness of nitrogen from inspiring English sources

According to some geology characteristics, such as top water, large thickness, high viscosity, of an actual reservoir in China, the minimum thickness of nitrogen layer is 12.06 m, and the volume of injected nitrogen is 47.86 × 104 m3, and the injection rate of nitrogen is 5957.96 m3/d when steam and nitrogen were simultaneously injected into reservoirs after SAGD stage.

The mesoscopic nitrogen-doped or undoped TiO2 sphere-based photoelectrode was coated on a fluorine-doped tin oxide [FTO] glass (TEC15; Pilkington TEC Glass™, IL, USA) by using a doctor blade and then sintered at 450°C for 30 min. The thickness of nitrogen-doped or undoped TiO2 sphere film was controlled by the thickness of scotch tape.

Application of high-voltage pulses to the workpiece (plasma-immersion ion implantation, PI3) increases the thickness of the nitrogen-rich layer but does not significantly alter the activation energy.

Exposure of samples to a pure hydrogen discharge prior to treatment in a pure nitrogen discharge increases both the thickness of and the nitrogen concentration in the treated layer compared to an unexposed sample.

Results indicated that the ratio of pineapple waste to binder, texture of the waste and thickness significantly affected emissions of nitrogen and phosphorus (p < 0.05).

A homogeneous microstructure was obtained for cermet sintered in 20-mbar nitrogen atmosphere, whereas the thickness of gradient layer increased with nitrogen pressure.

The oxide film thickness is reduced by implantation of nitrogen or noble metals.

Increase in the thickness and nitrogen concentration of nitrided layer is an important industrial requirement to improve the hardness, wear resistance, and several other properties in austenitic stainless steels.

The qualitative parameters of aquifer type, soil and impact of the vadose zone were replaced with the quantitative parameters of aquifer thickness, nitrogen losses from soil and hydraulic resistance.

The nitrogen-doped carbon-coated SnO2 hNFs (SnO2/NC hNFs) are composed of SnO2 hNFs with a wall thickness of 60 80 nm and a nitrogen-doped carbon layer ∼10 nm thick.

Both the thickness of nitrided layer and the nitrogen concentration at the outmost surface were found to increase with increasing gas nitriding pressure in the range of 133 798 Pa.